16
Using the Alarm Clock
Using the Alarm Clock
Your scanner’s Clock displays whenever you turn off the radio functions.
It can also be used as a standard alarm clock.
Setting the Current Time
Follow the steps to set the current time:
1. Move the slide switch to
Clock Set.
The hour digits flash.
2. Press
s or t to change the hour by one
hour increments or press the number keys
to select the present hour. Then press
E/PGM to set the hour. The minutes digits
flash.
3. Press
s or t to change the minute setting by one minute or press the
appropriate number keys to enter the minutes. The seconds reset to
00. Press E/PGM, AM/PM flashes.
4. Press
s or t to select AM or PM. To make your selection, move the
slide switch to Clock. The scanner exits the clock setting mode.
Setting the Alarm Clock
Follow these steps to set the alarm time:
1. Move the slide switch to
Alarm Set.
The hours digits flash.
2. Press
s or t to change the hour by one
hour increments or press the number keys
to select the present hour. Then press
E/PGM to set the hour. The minutes digits
flash.
3. Press
s or t to change the minute setting by one minute or press the
appropriate number keys to enter the minutes. Press E/PGM to set the
minutes. The AM/PM display icon flashes.
4. Press
s or t to move from AM to PM and back. Press E/PGM to
make your selection. To lock in the alarm time, move the slide switch
to Clock.
CAUTION: Be sure to follow all safety warnings provided with the
antenna. Failure to do so could expose you to risk of injury or death and
could severely damage the scanner.
Using the Backlight
To turn on the backlight for 5 seconds, tap SNOOZE/Backlight. To turn
on the backlight permanently, press and hold SNOOZE/Backlight for over
2 seconds. To turn off the backlight, press and hold SNOOZE/Backlight
again.
Country Mode (Australia/New Zealand)
The UBC340CRS is set to the Australian mode by default.
Australian mode: Australian service search frequencies and TV channel
frequencies.
New Zealand mode: New Zealand service search frequencies and TV
channel frequencies.
The country mode can be switched between Australia (AUS) and New
Zealand (nL) as follows:
1. Turn on the power while pressing down the
[HOLD] key.
The display will momentarily show
AUS for Australian mode or nL for
New Zealand mode.
The country mode is remembered for the next power on.
2. To change the country mode again, repeat step 1.
Setting Up The Scanner
UBC340CRS OM.indd 16 7/5/08 4:28:15 PM