Filter
Top Products
29
Special Features
BAND PLAN 3
See page 8 for how to switch the band between 1, 2
and 3.
Chain Search Mode
Press Func + Src to start chain search mode. SRCH,
the enabled search bank number, and or
(indicating the search direction) appear. The search
bank number being searched flashes.
Press 1-5 to enable or disable the search bank
number being searched in this mode. Enabled bank
numbers appear. (Disabled bank numbers
disappear).
At least one search bank must be enabled. (The
scanner sounds an error tone if you try to disable all
the search banks). The search bank and the
frequency where chain search starts depends on
how the scanner was set before you selected chain
search mode.
Chain Search Hold Mode
To start chain search hold mode, press Hold in
chain search mode. The scanner stops searching
and Hold appears. In this mode, pressing
Func + changes the search direction downward
and pressing Func + changes the search
Bank
No.
Frequency (MHz) Step (kHz)
1 25.0000 - 29.9950 5
2 160.6000 - 162.5950 5
3 162.6000 - 173.9950 5
4 440.0000 - 465.99375 6.25
5 466.0000 - 469.99375 6.25
UB334 Paper OM reduced size.fm Page 29 Friday, September 9, 2005 11:16 AM