Filter
Top Products
Installation
Vision Model 140/150 Owner’s Operating Manual 57
PRE
L
IMINAR
Y
previously (refer to Unlocking Channels on page 49), unlock the next channel and repeat the
calibration procedure. Do this for each of the remaining channels.
Installation MenuSelect Installation from the Vision 140/150 Main Menu to access these advanced lamp and
lens configuration options:
• LumaCal™, for maintaining constant lamp brightness
• OptiCal™, to save and restore lens positions
Calibration and Test Patterns – LumaCal (Lamp Calibration): LumaCal defines the range
of power needed to maintain lamp brightness over time.
To use LumaCal:
1. Select Installation from the Main Menu.
2. Select Calibration and Test Patterns from the Installation Menu.
3. Select LumaCal from the Calibration and Test Patterns Menu.
4. Select Calibrate LumaCal to calibrate the lamp using your projector's unique
specifications (recommended). Or, select Use Default Settings to undo the effects of a
previous calibration.
In the event of a power failure, the projector reverts to the default LumaCal settings in which
case you should re-calibrate the lamp.
1. Language English
2. Picture Orientation Front
3. Reserved
4. Auto Power Up
5. Set Date and Time
6. OSD Adjust
7. IR and Serial Adjust
8. Geometry and Color
9. Calibration and Test Patterns
0. Service Mode
Option 1 Card: Empty
Option 2 Card: Empty
Installation
1. Test Patterns Grid
2. Test Pattern Level 512
3. Freeze Image
4. Color Enable White
5. Odd Pixel Adjustment
6. Reserved
7. Clipping Detector
8. Level Detector
9. Level Value 512
0. Aspect Ratio Overlay
LumaCal Calibrate LumaCal
OptiCal Full
Automatic Lens Calibration
Calibration and Test Patterns
For best results, allow the projector to warm up for 15 minutes prior to
using LumaCal.
LumaCal lamp calibration takes approximately two minutes.
Note
Note