Filter
Top Products
Vidikron Vision Model 15 Installation/Operation Manual 1
1.1
About This Manual
This manual describes how to install, set up and operate a Vidikron Vision 15 Series Digital
Light Processing (DLP™) Projector. This product family consists of three models:
• Vision 15
• Vision 15ET (Extended-Throw)
• Vision 15ET/CineWide
Throughout this manual, all three projectors are referred to collectively as the “Vision 15.”
The information in this manual applies to all three projectors except where otherwise
indicated.
Vidikron has prepared this manual to help home theater installers and end users get the
most out of the Vision 15.
Vidikron has made every effort to ensure that this manual is accurate as of the date it was
printed. However, because of ongoing product improvements and customer feedback, it
may require updating from time to time. You can always find the latest version of this and
other Vidikron product manuals on-line, at www.Vidikron.com.
If You Have Comments About
This Manual...
Vidikron welcomes your comments about this manual. Send them to info@Vidikron.com.
Textual and Graphic
Conventions
Text Conventions: The following conventions are used in this manual, in order to clarify the
information and instructions provided:
• Remote and built-in keypad button identifiers are set in upper-case bold type; for
example, “Press EXIT to return to the previous menu.”
• Computer input (commands you type) and output (responses that appear on-screen) is
shown in monospace (fixed-width) type; for example: “To change the aspect ratio to
Letterbox, type RRD02.”
• All keys with functional names are initial-capped, set in bold type and enclosed in angle
brackets. These keys are the following: <Enter>, <Spacebar>, <Control>,
<Esc> and <Tab>.
• <Enter> indicates that you may press either the RETURN or ENTER key on your keyboard
if it has both keys.
In addition to these conventions, underlining, boldface and/or italics are occasionally used to
highlight important information, as in this example:
1Introduction
A carriage return must be used after each command or string.
Note