Filter
Top Products
E
N
G
L
I
S
H
ViewSonic PJ860
1
FOR YOUR RECORDS
The serial number of this product is on the bottom of the projector. Write the serial number in the
space below and keep this guide as a permanent record of your purchase to aid in identification in
the event of theft or loss.
Model Name: ViewSonic PJ860
Model Number: VPRJ21558-2
Document Number: PJ860-2_UG_181 (Rev. 1C)
Serial Number: ______________________
Purchase Date:
______________________
Copyright © ViewSonic Corporation, 1999. All rights reserved.
Macintosh and Power Macintosh are registered trademarks of Apple Computer, Inc.
Microsoft, Windows, Windows NT, and the Windows Logo are registered trademarks of Microsoft Corporation in the United
States and other countries.
ViewSonic and the three birds logos, and OnView are registered trademarks of ViewSonic Corporation. Office Theater is a
trademark of ViewSonic Corporation.
VESA and EDID are registered trademarks of the Video Electronics Standards Association (VESA). DPMS and DDC are
trademarks of VESA.
Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for
incidental or consequential damages resulting from furnishing this material, or the performance or use of this product.
In the interest of continuing product improvement, ViewSonic Corporation reserves the right to change product specifications
without notice. Information in this document may change without notice.
No part of this document may be copied, reproduced, or transmitted by any means, for any purpose without prior written permission
from ViewSonic Corporation.
FOR CUSTOMERS IN THE UNITED KINGDOM
THIS PRODUCT IS SUPPLIED WITH TWO PIN MAINS FOR USE IN MAINLAND EUROPE.
FOR THE U.K. PLEASE REFER TO THE CLASS I EQUIPMENT NOTES BELOW.
The mains lead on this equipment is
supplied with a moulded plug
incorporating a fuse, the value of which
is indicated on the pin face of the plug.
Should the fuse need to be replaced, an
ASTA or BSI approved BS 1362 fuse of
the same rating must be used.
If the fuse cover is detachable, never
use the plug without the cover. If a
replacement fuse cover is required,
ensure it is of the same colour as that
visible on the pin face of the plug. Fuse
covers are available from your dealer.
DO NOT cut off the mains plug from
this equipment. If the plug fitted is not
suitable for the power points in your
home or the cable is too short to reach
a power point, then obtain an
appropriate safety approved extension
lead or consult your dealer.
Should it be necessary to change the
mains plugs, this must be carried out by
a competent person, preferably a
qualified electrician.
If there is no alternative to cutting off
the mains plug, ensure that you first
remove the fuse then immediately
dispose of the portion remaining, to
avoid a possible shock hazard by
inadvertent connection to the mains
supply.
The wires in the mains lead are
coloured in accordance with the code
shown in the diagram below:
As these colours may not correspond
with the coloured markings identifying
the terminals in your plug, proceed as
follows:
The wire which is coloured Green and
Yellow must be connected to the
terminal in the plug which is marked
with the letter E or by the earth symbol
or coloured Green, or Green and
Yellow.
The wire coloured Blue must be
connected to the terminal marked with
the letter N or coloured either BLUE or
BLACK. The wire coloured BROWN
must be connected to the terminal
marked with the letter L or coloured
either BROWN or RED.
WARNING: THIS EQUIPMENT
MUST BE EARTHED
Green & Yellow to Earth
Blue to Neutral
Brown to Live
Fuse
Cord Clamp
Register your projector at www.viewsonic.com. It’s fast, easy, and will simplify future support needs.
Electronic Warranty Registration
Ef-PJ860.p65 01-May-01, 21:021