Filter
Top Products
ViewSonic PJ250 8
Turning the projector Off
1
Switch the power button off.
Main unit operation: Press and hold the POWER button for several seconds.
Remote control operation: Press the POWER OFF button.
The "Power off" indication will appear.
When the red bar extends fully (approximately 5
seconds), the projection screen will turn off and the
unit will enter the power off operation.
Note
• The operation can be cancelled by pressing a button other than the POWER button.
• One more press of the POWER (POWER Off) button will switch off the power.
When the unit enters the standby mode the POWER
indicator changes from a flashing amber and lights a
steady amber after about 90 seconds.
2
Unplug the power cable.
Check that the POWER indicator is lit amber and then unplug the power cable.
The POWER indicator will go off when the power cable is unplugged.
WARNING:
Do not unplug the power cable while the POWER indicator is flashing amber. Doing so may shorten
the life of the lamp or damage the projector.
Flashes amber
(Approximately
90 seconds)
Lit amber
Standby mode