Filter
Top Products
ViewSonic PJ452
41
Maintenance
Lamp
WARNIN G
HIGH VOLTAGE
HIGH TEMPERATURE HIGH PRESSURE
►The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud
bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that
each lamp has a different lifetime, and some may burst or burn out soon after you start
using them. In addition, when the bulb bursts, it is possible for shards of glass to fly into
the lamp housing, and for gas containing mercury to escape from the projector’s vent
holes.
►About disposal of a lamp • This product contains a mercury lamp; do not put in
trash. Dispose of in accord with environmental laws.
For lamp recycling, go to www.lamprecycle.org. (in the US)
For product disposal, contact your local government agency or www.eiae.org (in the
US) or www.epsc.ca (in Canada).
For more information, call your dealer.
Disconnect
the plug
from the
power outlet
• If the lamp should break (it will make a loud bang when it does), unplug
the power cord from the outlet, and make sure to request a replacement
lamp from your local dealer. Note that shards of glass could damage the
projector’s internals, or cause injury during handling, so please do not try
to clean the projector or replace the lamp yourself.
• If the lamp should break (it will make a loud bang when it does),
ventilate the room well, and make sure not to breathe the gas that comes
out of the projector vents, or get it in your eyes or mouth.
• Before replacing the lamp, turn the projector off and unplug the power cord, then
wait at least 45 minutes for the lamp to cool sufficiently. Handling the lamp while
hot can cause burns, as well as damaging the lamp.
• Never unscrew except the appointed (marked by an arrow) screws.
• Do not open the lamp cover while the projector is suspended from above.
This is dangerous, since if the lamp’s bulb has broken, the shards will fall out
when the cover is opened. In addition, working in high places is dangerous, so
ask your local dealer to have the lamp replaced even if the bulb is not broken.
• Do not use the projector with the lamp cover removed. At the lamp replacing,
make sure that the screws are screwed in firmly. Loose screws could result in
damage or injury.
• Use only the lamp of the specified type.
• If the lamp breaks soon after the first time it is used, it is possible that
there are electrical problems elsewhere besides the lamp. If this happens,
contact your local dealer or a service representative.
• Handle with care: jolting or scratching could cause the lamp bulb to burst during use.
• If the indicators or a message prompts you to replace the lamp (see the
section “Related Messages” and “Regarding the indicator Lamps”), replace the
lamp as soon as possible. Using the lamp for long periods of time, or past the
replacement date, could cause it to burst. Do not use old (used) lamps; this is a
cause of breakage.