S-VIDEO VIDEO
AUDIO IN
OUT
RGB IN2 RGB OUT RGB IN1
CONTROL
Part names
Lens
Lens cover
Filter cover
(Air filter and intake vent
are inside.)
Elevator button
Elevator foot
Remote sensor
Focus ring
Vent
AC inlet
Power switch
Elevator button
S-VIDEO port
VIDEO port
CONTROL port
Part names
Projector
Lamp cover
(Lamp unit is inside.)
Elevator foot
Bottom side
Speaker
Front-Right side
Rear-Left side
Control buttons
Ports
(See below.)
Vent
Ports
Restart switch
Kensington lock slot
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
AUDIO-OUT port
AUDIO-IN port
RGB IN1 port
RGB IN2 port
RGB OUT port
Zoom ring
4ViewSonic PJ452