Filter
Top Products
10
Operation
Starting up the projector
1. Plug the power cord into the projector and into a
wall socket and power adaptor. Plug DC jack to projector.
Check that the POWER indicator light on the projector
flashes blue after power has been applied.
2. Remove the lens cap. If it is closed, it could
become deformed due to the heat produced by the
projection lamp.
3. Press POWER on the projector or remote control
to start the projector. The POWER indicator light stays
blue when the projector is on. The start up procedure
takes about 20 seconds. In the later stage of start up, a
startup logo is projected. (If necessary) Rotate the focus
ring to adjust the image clearness.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message “Signal out
of range”, please set the computer output to 800X600'
Use the Menu
The projector is equipped with On-Screen Display (OSD) menus for making various adjustments and settings. Below is
the overview of the OSD menu.
Important: Use
to highlight function and press Enter to select.
Main menu icon
PJD2121ViewSonic