VTech 2S Graphics Tablet User Manual


  Open as PDF
of 44
 
4
Backup Battery Slot & Cover The backup battery provides power for
the clock. For backup battery replacement
instructions, please see the Care &
Maintenance section on page 25.
Wrist Strap Fastener If you wish, attach a wrist strap here.
(NOTE:
Wrist strap not included.)
Slide this switch to open the battery door.
Always replace the InnoTab
®
2S battery door
after changing batteries.
SD Memory Card Slot Insert an SD memory card (not included).
(NOTE: InnoTab
®
2S is compatible with SD memory
cards and SDHC memory cards up to 32GB.)
Battery Compartment Insert 4 “AA” batteries (not included). For
battery installation instructions, please see
the next section.
Stand Pull out this stand to prop up InnoTab
®
2S
and use it as a digital photo frame.
Battery Installation
•Makesurethetabletisturnedoff.
•Locatethebatterydoorlockslidingswitchonthe
back of the tablet. Slide the switch to open the
battery door, then remove the door.
•Insert4“AA”batteriesasshowninimage2.
•Makesuretoreplacethebatterycover.
Battery Notice
• Non-rechargeablebatteriesarenottoberecharged.
• Rechargeablebatteriesaretoberemovedfromthetoybeforebeing
charged (if removable).
• Rechargeablebatteriesareonlytobechargedunderadultsupervision
(if removable).
• Donotmixoldandnewbatteries.
2
1
G
E
T
T
i
N
G
S
T
a
r
T
E
d
Battery Door Lock Sliding
Switch
 previous next