Filter
Top Products
The DTI-520 Display
* Depending on the specifications and settings of your computer and video
card, when in standby and suspend modes, the power lamp may only light
up orange.
This product is in compliance with VESA and ENERGY STAR power-saving guidelines. When
connected to a Display Power Management (DPMS)-compatible computer and graphics board, the
power savings indicated below are automatically realized during times of non-operation.
Computer
Activity
Horizontal
Synchronizing
Signal
Vertical
Synchronizing
Signal
Picture
Signal
Power
Consumption
Power Lamp
Turned On Yes Yes Yes 23W or less Blue
Stand-by Mode No Yes No Less than 2W Orange/Blue*
Suspend Mode Yes No No Less than 2W Orange/Blue*
Off Mode No No No Less than 1W Orange
The DTI-520 Power Saving Function
Either an image input from the RGB – RGB cable (see P. 11) or an image input from the composite
video cable (see P. 11) will be displayed on the DTI-520. Either of these images can be replaced by
using the following method:
●
Switch at the INPUT CONVERSION screen, which can be assessed from the menu screen.(
▶
P.17)
●
Click on the ENTER button.(
▶
P.15)
Switching Display Images
If both the RGB – RGB cable and the composite video cable are connected,
and then you turn the unit on, the image input from the RGB – RGB cable takes
priority and is displayed.
Important
In order to ensure optimal display image quality, this product utilizes the Auto-Adjust function. When
the Auto-Adjust function is operating, it may take a short time before the screen displays properly.
The settings initiated by Auto-Adjust are saved in the display.
If the Auto-Adjust function is operating, the horizontal and vertical positions as
well as the phase and pitch of the display are adjusted automatically when the
display mode is received. The Auto-Adjust function becomes operational when
the horizontal frequency is in the 30-56.5KHz and the vertical frequency is in the
45-75Hz range.(When resolution is 1024 × 768 dot (XGA), vertical frequency is in
the 45-70Hz range)
When the Auto-Adjust function is operating, only the power switch is operational
.
The Auto-Adjust Function
Hint
Caution
Hint
User's Guide
UM-0314(A)_EN.indd 13 2007/11/12 16:53:15