Filter
Top Products
Make sure both the ribbon access window and the printer top cover are
closed when powering up the printer.
3.3 Loading Label Stock
1. Insert a 1” label spindle into the label roll. If your paper core is 1 inch, you
can remove the 1.5” core adapters from the centering tab. If the label width
is 4 inches wide, the two centering tabs are not required.
Figure 4: Label Roll Installation
2. Open the printer’s top cover by pulling the yellow top cover open levers
located on each side of the printer and lifting the top cover. A top cover
support at the rear of the printer will hold the printer top cover open.
Figure 5: Pull the lever to open the cover
3. Place the roll of labels onto the center of the paper roll mount.
Lower Cover
1” Label Spindle
Printing Side
Face Up
1.5” Core Adapter
Centering Tab