Filter
Top Products
Figure 6: Label installation
4. Feed the paper, printing side face up, under the Teflon bar and the paper
guide and pass over the platen.
5. Adjust the yellow center-biased paper guides to slightly touch the edges of
the label backing.
6. To close the printer top cover, lift the cover to the ultimate open angle then
use both hands to close the cover gently. Close the printer top cover
slowly and make sure the cover locks latch securely.
Note:
1. Make sure hands are not placed in the printer when close the top
cover.
2. Do not allow the top cover to slam closed.
3. Failure to securely close and lock the cover will result in poor
print quality.
3.7 Top Cover Operation
To Open:
1. When facing the front of the printer pull the cover release levers on both
sides of the printer towards you.
2. Lift the top gradually.
There are two stop positions for the top cover. Position 1 and 2 are
indicated on the label below.
Note: To hold the cover open at position 1, you must lift the cover
higher than the stopping point at position 1 and gently lower the
cover to stopping point 1. Do not let the cover free fall!
3. Fully open the top cover and gently lower it to stop position 2.
Printer Top Cover
Support Bar
Paper Guide
Teflon Bar
Top Cover Open Lever
Paper Roll Mount