Filter
Top Products
030-300381 Rev. A 16 January 2004
UltraLine Home DSL Router (Models 7400, 7401)
User Guide
3. Connect the yellow Ethernet cable from any one of the Ethernet jacks marked
on the rear panel of the
Router to the Ethernet port on your computer. Repeat this step to connect up to three additional PCs to the
Router.
NOTE: You may connect to any of the four Ethernet jacks on the rear panel of the Router as they serve as an
Ethernet switch.
4. Connect the blue USB cable from the blue USB connector marked
on the rear panel of the Router to the
USB port on the PC.
5. Check to see if the DSL/RDY LED is solid green. If the DSL/RDY LED is solid green, the Router is
functioning properly.
6. Check to see if the Ethernet LED (on the back of the unit) lights solid yellow or solid green. Solid green
indicates the Ethernet connection is functioning properly in 100 Base-T mode. Solid yellow indicates the
Ethernet connection is functioning properly in 10 Base-T mode.
Congratulations! You have completed the simultaneous hardware (Ethernet and USB) installation for Model 7400.
You must now go to section 7 to begin the USB driver software installation. (No software installation is required
when using only an Ethernet connection.)