Filter
Top Products
®
15
C
harging
Indicators
C
harging
Pins
Cord Hook
Power Input
C
harging
Contact Holes
FIGURE 1
0: U
SING THE OPTIONAL C
HG 200A B
ATTERY CHARGER TO CHARGE THE P
FM T31 T
RANSMITTER
Step 1: Plug the CHG 200’s power supply into
the Power Input on the charger’s side and
a standard AC wall outlet.
Step 2: Route the power cord around the Cord
Hook (see figure at right). This will
minimize strain on the cord and jack and
insure that the power cord is not detached
during charging.
Step 3: Make sure the transmitters to be charged
are turned OFF.
Step 4: Place the transmitters in the slots so that
the CHG 200’s Charging Pins and
receiver’s side panel contacts are
coupled. Make sure that the charging
contact holes line up with the char
ging
pins. The transmitters should drop easily
into the slots. DO NOT FORCE THEM
IN BACKW
ARDS.
Step 5:
The Char
ging Indicators will light,
indicating that charging is in process.
It takes 14–16 hours to fully charge the
batteries. Remove the transmitters when
charging is completed.
!! WARNING !!
DO NOT ATTEMPT TO RECHARGE DISPOSABLE BATTERIES!
The batteries may heat up and burst, causing possible injury and damage to the equipment.
Avoid shorting the plus and minus battery terminals together with metal objects. Battery damage and
burns can result!
Use only Williams Sound supplied chargers and batteries.
FURTHER SUGGESTIONS
Receivers should always be turned OFF while charging.
It’s best to allow the batteries to fully discharge before charging.
If the batteries are near end of life and the LED turns of
f while the receiver is operating, this is an
indication to change or recharge your batteries. Approximately one hour of battery life remains.
Rechargeable batteries will need to be replaced after 1–2 years of use.