Filter
Top Products
Appendix A: Using Wireless Scanners with Furniture Wizard
61
Figure 53: Internet Protocol (TCP/IP) Properties Page
Original TCP/IP Network Settings
6. Once you have accessed the Internet Protocol (TCP/IP) Properties page (Figure 53), do the
following:
Manually record each of the network settings, as they are presently displayed in the
Properties page, in Section 1 of the Settings Worksheet (entitled “Current
Local Area Network Settings”); this worksheet can be found in the Appendix
section of this manual. Manually recording these settings is critical to the
successful setup of your wireless network! You will be setting your local area
network back to its original settings after testing for proper communications with
the Access Point receiver.
Failure to record your original network settings in Section 1 of the Settings
Worksheet will result in possible interrupted (or failed) operation of your local
area networking operations!!
Note that if your TCP/IP configuration is set to Obtain IP Address Automatically
or Obtain DNS Server Address Automatically (Figure 54), you will first need to
re-configure your network to use static IP addresses because the scanner units
require use of static IP addresses that will not change.
If you are unsure of how to reconfigure your network to use static IP addresses,
please contact a local network technical expert for further assistance!!