Filter
Top Products
08905107C - 3 -
PROGRAMMING
A. Accessing Programming
1. Accessing the Programming Mode with a Security Code
Step 1.
Come off-hook with any house phone (device) connected to terminals 4 & 5,
LINE OUT TO PHONES.
Step 2.
Enter *# followed by the 6-digit security code (factory set to 845464).
Step 3.
A double beep will indicate that you have accessed the programming mode.
Step 4.
You can now Touch Tone program the features listed in section B below.
Step 5.
When finished programming, hang up.
2. Accessing the Programming Mode Locally (Security Code Bypass Mode)
Note: This mode is useful for programming the DCH4 without a telephone line connected.
Step 1.
Move DIP switch 2 from OFF to ON (Security Code Bypass Mode, see DIP
Switch Programming section D).
Step 2.
Come off-hook with any house phone connected to terminals 4 & 5, LINE
OUT TO PHONES
Step 3.
A double beep will indicate that you have accessed the programming mode.
Step 4.
You can now Touch Tone program the features listed in section B below.
Step 5.
When finished programming, hang up and move DIP switch 2 to the OFF
position.
3. Accessing the Programming Mode Remotely
Step 1.
Call into the DCH4 from a Touch Tone phone. Note: Call in from another line
to avoid C.O. busy signals, etc.
Step 2.
Answer the call from any house phone (device) connected to terminals 4 & 5,
LINE OUT TO PHONES.
Step 3.
From either phone enter *# followed by the six digit security code (factory set
to 845464, see Programming section C).
Step 4.
A double beep will indicate that you have accessed the programming mode.
Step 5.
You can now Touch Tone program the features listed in section B below.
Note: Programming from a cell-phone may not be suitable in areas with weak coverage.