Xantrex Technology GT Series Switch User Manual


 
Installation
153553 3
For use by qualified technicians only
Installing the Ethernet Communications Kit
You will have to make connections to the CCU control board inside of the
enclosure. Use caution not to discharge any static electricity onto the
control board.
Use the following procedure to install the new Ethernet
Communications Kit:
1. Install the panel with the four M6 nuts.
2. Connect the fiber optic cable to the RS232/Fiber adapter.
3. Connect the orange cable to the TX connector on the RS232/Fiber
adapter.
4. Connect the blue cable to the RX connector on the RS232/Fiber
adapter. See Figure 2.
Figure 1
Panel with Four M6 Nuts
M6 Nuts
Ethernet.book Page 3 Thursday, May 29, 2008 4:20 PM