Filter
Top Products
Connecting DC Cables
3–15
To connect the DC cables:
1. Cut the cables to the correct length.
2. Strip the appropriate amount of insulation off one end of each cable and
attach the connectors that will join the cables to the battery, battery
isolator switch, or fuse block. The connectors you use must create a
permanent, low-resistance connection.
If you are using crimp connectors, use the tool recommended by the
terminal manufacturer. Make sure no stray wires protrude from the
terminal. (You may find it more convenient to have the crimp
connectors attached by the company that sells you the cable.)
3. Strip about 1/2 inch (1.25 cm) from the ends of the cables that will be
connected to the inverter.
Figure 3-6 Configuration for Heavy Loads
FROM ALTERNATOR
OR CHARGER
TO VEHICLE
VEHICLE
STARTING
BATTERY
DEEP-CYCLE
BATTERY
DEEP-CYCLE
BATTERY
DEEP-CYCLE
BATTERY
DEEP-CYCLE
BATTERY
FUSE OR
CIRCUIT
BREAKER
FUSE OR
CIRCUIT
BREAKER
BATTERY
SELECTOR
SWITCH
BATTERY ISOLATOR
BATTERY
SELECTOR
SWITCH
TO DC
LOADS
PROwatt
1000
GROUND TO
VEHICLE
CHASSIS
GROUND TO
VEHICLE
CHASSIS
GROUND TO
VEHICLE
CHASSIS
ALL
OFF 2
1
ALL
OFF 2
1
FUSE OR
CIRCUIT
BREAKER
FUSE OR
CIRCUIT
BREAKER
PROWatt100.book Page 15 Friday, January 5, 2001 3:03 PM