Filter
Top Products
11 Setups
Xerox Phaser 3635 User Guide 193
Machine Tests
Should you need to report any faults to the machine, the Xerox Welcome Center
support may talk you through the following machine tests to verify the
performance of the machine and user interface (UI) screen.
Image Quality Test Patterns
Use the scroll buttons to select one of the 19 available test patterns.
Select the Feature button to test either 1 sided or 2 sided printing from the
available trays.
Select the Start Test button to begin the test.
Tools > Device Settings > Tests & Resets > Image Quality Test Patterns
User Interface Tests
User Interface Button Test
The UI Button Test verifies that all of the buttons on the panel are functioning
properly.
1. Ensure that the selection audio tones are enabled - refer to Audio Tones in the
Setups chapter on page 184.
2. Select Start Test to begin the test.
3. Press each button on the panel to the right of the touch screen. A short audio
tone will be generated if the button is functioning properly.
4. Select End Test to end the test. The Test Pass/Fail screen displays.
5. Select the Passed button if all the buttons on the User Interface are
functioning properly. Select the Failed button if any of the buttons on the UI
are not functioning properly.
Tools > Device Settings > Tests & Resets > User Interface Button Test
Touch Area Test
The Touch Area Test verifies that all touch areas on the display are responding.
1. Select Start Test to begin the test. Then touch the display. If the display is
functioning properly, the selectable area will toggle between white and black
each time the area is touched.
2. Press 1 on the keypad to indicate the test was successful. Press 2 on the
keypad to indicate the test was not successful.