Filter
Top Products
PREINSTALLATION
Shared space
It is always best to provide the full amount of clearance space
around your LPS. It is sometimes necessary, however, to have
shared space between components, such as between the printer
and the system controller, or between the 4050, 4090, 4450, or
4650 LPS and another printing system. It is possible to share the
36 inch/914 mm clearance space around each component, but
there are three rules which must always be observed:
• Space may be shared only with other Xerox equipment.
• Components may share the 36 inch/914 mm general service
clearance areas, but they may not share the 24 inch/609 mm
operator area in front of each component.
• There must be 78 inches/1,981 mm of vertical clearance
throughout the entire area.
Figures 1-8 and 1-9 illustrate two possible configurations of
shared space. In the first illustration, two printers are back to
back. Because there is no operator area to be concerned with,
the entire 36 inches/914 mm of general service space may be
shared.
Figure 1-8. Back-to-back shared service area space
Figure 1-9 shows the two printers facing each other. The printers
share 12 inches/305 mm of the general service space but not the
exclusive operator area in front of each printer. Therefore, the
printers must be 24 inches/610 mm + 24 inches/610 mm + 12
inches/305 mm apart: the entire operator space for each printer
plus the shared general service area of 12 inches/305 mm.
1-14 XEROX 4050/4090/4450/4650 LPS INSTALLATION PLANNING