Filter
Top Products
PREINSTALLATION
Table 1-21. Hardware requirements
System Requirements
VMS/UNIBUS
• Supported VAX series hardware configuration (CPU,
memory, peripherals) with UNIBUS I/O subsystem
• DMR11-M synchronous interface and cabinet kit.
VMS/VAXBI
• Supported VAXBI series hardware configuration (CPU,
memory, peripherals)
• DSB32-AA synchronous interface and cabinet kit.
VMS/Q-bus
• Supported MicroVAX hardware configuration (CPU,
memory, peripherals)
• DSV11 Q-bus synchronous interface and cabinet kit.
Software requirements
The VAX-resident print supervisor (symbiont) software requires
the following supported software:
• VMS Version 5.0 (or later)
• VAX Wide Area Device driver.
Documentation
A number of reference manuals are available to assist you in
maximizing the productivity of your LPS. The reference set for
your LPS is delivered with the equipment at installation. All of
the manuals may be ordered as a set or individually.
References Refer to the “Ordering documentation and software” section of
the “Postinstallation” chapter for procedures on how to order
additional documentation and the Xerox Customer
Documentation Catalog.
Training
This section describes the training available through Xerox.
Operator training Operator training is conducted at your location shortly after your
LPS is installed. Training takes approximately four to seven
hours, depending on the system configuration, and includes
hands-on practice running basic jobs, maintenance, and problem
solving. Determine the number of operators you want to attend
the initial training, and schedule training dates and costs through
your sales representative and system analyst.
Advanced Customer Training (ACT) is available at the Xerox
training center in Leesburg, Virginia. Discuss candidates for this
training with your sales representative, if desired. Keep in mind
that operators should not be considered for ACT until they have
1-26 XEROX 4050/4090/4450/4650 LPS INSTALLATION PLANNING