Filter
Top Products
Printer components and options
3-14 System Overview Guide
• Alignment: Your finishing device align at the correct height
without interference from protruding features. To accomplish
this, you must consider the feature locations and the vertical
alignment.
• Paper exit: The finishing device must align with this exit slot.
Printed sheets travel through the printer output module and
bypass transport, out of the paper exit, and into the finishing
device. The paper exit slot is 16.75 inches (425.45 mm) wide.
• Module mobility: Your finishing device must be easy to
move so that you can align it precisely.
The following figure illustrates the alignment and docking
locations for the bypass transport on the printer (the bypass
transport support is not shown).
Figure 3-10. Alignment and docking locations (in
millimeters)
1. Sheet registration edge
2. Sheet edge
3. Vertical slot to accept 13 mm
4. Floor
5. 22 mm diameter docking zone
6. Center line of docking features