Filter
Top Products
Phaser® 6300/6350 Color Laser Printer
A-3
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation
of your printer.
Printer Location
Place the printer in a dust-free area within a temperature range of 41° F to 90° F (5° C to
32° C) and a relative humidity range of 15 percent to 85 percent.
Printer Clearance
Place the printer in an area where there is adequate space for ventilation, operation, and
servicing. The recommended minimal spacing is:
Overhead Clearance:
■ 350 mm (14 in.) above the printer
Total Height Requirements:
■ Printer: 457 mm (18.3 in.)
■ Add 130 mm (5.2 in.) for the 550-Sheet Feeder.
■ Add 341 mm (13.6 in.) for the 1100-Sheet High-Capacity Feeder.
Other Clearances:
■ 100 mm (4 in.) behind the printer
■ 600 mm (24 in.) in front of the printer
■ 100 mm (4 in.) on the left side of the printer
■ 100 mm (4 in.) on the right side of the printer
Operational Guidelines
■ Do not block or cover the slots and openings on the printer. The printer may overheat
without adequate ventilation.
■ For optimum performance, use the printer at elevations below 3,000 m (11,480 ft.).
■ Do not place the printer near a heat source.
■ Do not place the printer in direct sunlight to avoid exposing light-sensitive components
when the doors are open.
■ Do not place the printer in line with the cold air flow from an air conditioning system.
■ Place the printer on a level, solid non-vibrating surface with adequate strength for the
weight of the printer. It should be within 2° of horizontal with all four feet in solid contact
with the surface. The base printer weight without any packaging materials is
approximately 35 kg (77 lb.).