Filter
Top Products
Operation
This section explains how to operate the CRW6416SX drive after you have
installed it.
Loading a Disc
1 Press the Eject button on the CRW6416SX drive’s front panel.
2 Place the disc onto the tray with its label or printing facing upward.
3 Press the Eject button to close the tray.
n When a disc is loaded, the ON/DISC LED is lit up in orange first, then changes to green. For
more details, refer to page 30.
n Do not push or pull the tray using excessive force. Doing so can damage the drive or the disc.
Instead, always use the Eject button to open or close the tray.
Ejecting the Disc
1 Press the Eject button on the CRW6416SX drive’s front panel.
2 Remove the disc from the tray.
3 Press the Eject button to close the tray.
n The disc tray will not open if the computer is not switched on. Also, depending on the SCSI
adapter card settings, it may not open if the drive is busy reading a disc.
n Only remove the disc after the disc tray has opened fully. Otherwise, you risk damaging the
drive or the disc.
1 2
1 2
22
CRWSX_e.qx 7/8/99 3:08 PM Page 29