Filter
Top Products
■ About CD-R/RW discs
Please read the following regarding the handling of CD-R/RW discs.
1. Do not expose discs to excessive heat or vibrations or extreme cold or heat (such as in
direct sunlight or near a heater).
2. Do not touch disc surfaces.
When handling a disc, hold it by its edges.
3. Remove dust and dirt from disc surfaces.
Use air-based dust removers. The surfaces may be scratched if wiped with a dry cloth.
4. Do not write or stick labels on disc surfaces except where indicated.
5. Do not clean discs with chemicals or detergents.
6. Do not bend or drop discs.
1. The information contained in this manual is subject to
change without prior notice.
2. All trademarks contained in this manual belong to their
respective owners.
3. Yamaha does not bear any responsibility for any outcome
as a result of using this device.
4. Reproduction of this manual, either in part or in full, is
expressly forbidden.
n Electrical plugs/sockets vary according to country/region.
■ Precautions for Transportation
Before transporting the device, always place the transportation pad on the disc tray and
put the device back in its original box . If the device is transported without adequate
packing, the internal components can become damaged and cause the device to
malfunction.
■ Distributing Discs
When writing important data or preparing data for distribution to others, make sure that the
disc can be read properly before writing duplicates.
■ Copyrights
When writing to CD-R/RW, make sure that you are not infringing any copyrights. It is
illegal to copy audio CDs for non-personal use. When backing up software, please make
sure that you are not infringing any software copyrights for that product.
■ WARRANTY
YAMAHA AND SUPPLIERS ACCEPT NO LIABILITY FOR THE LOSS OF ANY DATA OR ANY
PROBLEMS CAUSED AS A RESULT. AS A PRECAUTION, IT IS RECOMMENDED THAT
THE DISCS ARE TESTED AFTER THEY HAVE BEEN WRITTEN TO. FURTHERMORE,
UNDER NO CIRCUMSTANCES DOES YAMAHA AND SUPPLIERS GUARANTEE THE
RELIABILITY OF THE MEDIA.
iv
CRWSX_e.qx 7/8/99 3:08 PM Page 6