Filter
Top Products
ENGLISH
8
MY8-SDI-D Owner’s Manual
OFF:
A filter is not applied to a detected HD-SDI input error. Each STATUS LED
indicates the type of all HD-SDI input errors as shown in the list below. Audio
will be muted if SW6 is set to ON.
HD-SDI Input Errors
ON:
A filter is applied to a detected HD-SDI input error (excluding the video
standard error). The STATUS LEDs will not indicate an error status. Audio will
be input to the slot channels, and will not be muted regardless of the SW6 setting.
E
ERROR FILTER Switch (SW8)
Typically set this switch to OFF. This switch is used to analyze the causes of
errors.
OFF:
A filter is not applied to a detected embedded audio error. Each STATUS
LED indicates the type of error as shown in the list below. Audio will be muted if
SW6 is set to ON.
Embedded Audio Errors
ON:
A filter is applied to a detected embedded audio error marked with a [—] in
the list above. The STATUS LEDs will not indicate the status of errors marked
Details
ON OFF
Video standard error error error
Chromaticity checksum error — error
Brightness checksum error — error
Chromaticity CRC error — error
Brightness CRC error — error
Line number error — error
Start of active line (SAV) code word error — error
End of active line (EAV) code word error — error
Details
ON OFF
UNLOCK error error
Presence of any audio group packet error error
CRC error of video signal sent to audio block error error
Phase data error of the selected audio group(s) error error
Data block number error — error
Parity error in audio packet — error
Error correcting code error — error
Checksum error in the selected audio group(s) — error