Filter
Top Products
COMPLIANCE INFORMATION STATEMENT
(DECLARATION OF CONFORMITY PROCEDURE)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT
MODIFY THIS UNIT!
This product,
when installed as indicated in the instruc-
tions contained in this manual, meets FCC
requirements. Modifications not expressly
approved by Yamaha may void your
authority, granted by the FCC, to use the
product.
2. IMPORTANT:
When connecting this
product to accessories and/or another
product use only high quality shielded
cables. Cable/s supplied with this product
MUST be used. Follow all installation
instructions. Failure to follow instructions
could void your FCC authorization to use
this product in the USA.
3. NOTE:
This product has been tested and
found to comply with the requirements
listed in FCC Regulations, Part 15 for
Class “B” digital devices. Compliance with
these requirements provides a reasonable
level of assurance that your use of this
product in a residential environment will not
result in harmful interference with other
electronic devices. This equipment gener-
ates/uses radio frequencies and, if not
installed and used according to the instruc-
tions found in the users manual, may
cause interference harmful to the opera-
tion of other electronic devices.
Compliance with FCC regulations does not
guarantee that interference will not occur in
all installations. If this product is found to
be the source of interference, which can be
determined by turning the unit “OFF” and
“ON”, please try to eliminate the problem
by using one of the following measures:
Relocate either this product or the device
that is being affected by the interference.
Utilize power outlets that are on different
branch (circuit breaker or fuse) circuits or
install AC line filter/s.
In the case of radio or TV interference,
relocate/reorient the antenna. If the
antenna lead-in is 300 ohm ribbon lead,
change the lead-in to co-axial type cable.
If these corrective measures do not pro-
duce satisfactory results,
please contact the local retailer authorized
to distribute this type of product. If you can
not locate the appropriate retailer, please
contact Yamaha Corporation of America,
Customer Service Division, 6600
Orangethorpe Ave, Buena Park, CA90620
The above statements apply ONLY to
those products distributed by Yamaha Cor-
poration of America or its subsidiaries.
*This applies only to products distributed by YAMAHA CORPORATION OF AMERICA
(class B)
Responsible Party: Yamaha Corporation of America
Address: 6600 Orangethorpe Ave., Buena Park,
California 90620
Telephone: 714-522-9011
Type of Equipment: USB-MIDI Interface
Model Name: UX16