Filter
Top Products
Doc# 27-0001UM Issued 7/99 Rev. 1.2
TOOLS REQUIRED
PRECAUTIONS
Required Tools and Equipment
Flathead screwdriver with about 10"
shaft.
Phillips screwdriver with about 10"
shaft.
Computer Setup Diskette
In preparation to install the Com-
mand Console, take the following
precautionary steps:
Turn off the electrical power to your
computer.
Verify the Command Console power
switch is off. If the Console is off, the
light will not be illuminated.
DANGER: To avoid shock hazard:
Do not remove the covers around
the Command Console.
Do not connect or disconnect the
Command Console during an
electrical storm.
The power cord plug must be
connected to a properly wired
and grounded power outlet.
Any equipment to which the
Command Console will be
attached must also be connected
to properly wired and grounded
power outlets.
NOTE: For the fastest and easiest
installation of the
Command Console, follow
these steps in the sequence
they are presented.
Starting Point
6