Filter
Top Products
Chapter 2 Basic Installation
System Requirement
Before installing the ZMAX-8210 Customer Premise Equipment, make sure your system meets these
requirements
A PC coupled with 10/ 100Base-TX adapter
Configure the computer with a static IP address of 192.168.1.x (x cannot be 1) and 255.255.255.0
for the Subnet Mask
A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, or Netscape
Navigator 4.78 or above or Firefox
Package Content
If any missing or damaged, please contact your local seller.
Z-Com ZMAX-8210 Customer Premise Equipment
Power adapter and cord （48V，1A）
Accessories (For its full contents, please refer to accessory installation guide)
ZMAX-8210 Customer Premise Equipment Installation Guide
Hardware Installation
Follow the steps below to install your ZMAX-8210. (the different of hardware installation between
ZMAX-8210-I and ZMAX-8210-E is antenna)
Make sure all components linked to the ZMAX-8210 are on hand.
A brace fixed on the back of the ZMAX-8210 is tabled on a perfect area like well-sized desk.
Attach one end of water-proof cable to a water-proof connector. Alternatively, you can make a
Category 5 UTP straight yourself.
Chapter 2
Introduction - 5 -