Filter
Top Products
O-17
UMAN-EN2+
continued next page
Never use any sharp objects on printer mechanism as
it could damage the print head and platen. Use
only the supplied cleaning pen or a cotton swab
saturated with alcohol for cleaning. Always turn the
printer off prior to any cleaning operation.
Cleaning the print head:
•Open the printer. Press the “Open” button on the
front of the unit and swing the print head open.
•Use the alcohol and cotton swabs supplied in the
Cleaning Kit to clean the surface of the print head, the
platen (print roller), the peeler bar and the peeler
roller.
Cleaning the platen (print roller):
Applies to printers configured for linered media only
•Open the printer. Press the “Open” button on the
front of the unit and swing the print head open.
•Use the cleaning pen or a cotton swab saturated with
alcohol to clean the platen. Rotate it to expose the
entire surface.
Cleaning the peeler roller:
Applies only to units with label peeler option
•Saturate a cotton swab with alcohol. Gently clean the
ridges of peeler roller with swab to remove label
adhesive residue. Rotate the peeler roller as needed.
Cleaning Sensors
Bar/Gap Sensor:
• The Bar/Gap sensor is located in the right side of the
media compartment behind the platen. Blow out any
dust deposits carefully, then finish cleaning with a
swab saturated in alcohol.
Label Presence Sensor:
• The label presence sensors are located on the out-
side of the print head. Remove any material blocking
the lenses, blow out any dust deposits carefully, then
finish cleaning with a swab saturated in alcohol.