Filter
Top Products
iv P120i Card Printer User Guide 980504-001 Rev. A
Foreword
Return Materials Authorization
Declarations of Conformity
For a formal certificate, please contact the Compliance Office at Zebra’s Camarillo facility.
EUROPE:
Norway Only: This product is also designed for IT power system with phase to phase voltage 230V.
Earth grounding is via the polarized, 3-wire power cord.
FI: “Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan”
SE: “Apparaten skall anslutas till jordat uttag”
NO: “Apparatet må tilkoples jordet stikkontakt”
Supplemental Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference’s by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet, prepared by the Federal Communications Commission, helpful:
How to identify and resolve Radio/TV Interference Problems. This booklet is available from the U.S.
Government printing Office, Washington, D.C. 20402, Stock No. 004-000-00345-4. Use of a shielded cable is
required to comply within Class B limits of Part 15 of FCC Rules. Pursuant to Part 15.21 of the FCC Rules, any
changes or modifications to this equipment not expressly approved by Zebra may cause, harmful interference
and void the FCC authorization to operate this equipment.
89/336/EEC
modified by
92/31/EEC and
93/68/EEC
EMC Directive
EN 55022 (1998)
RF Emissions control
EMC Directive
EN 301489-3
V1.4.1
RF Emissions and Immunity for
radio equipment
EMC Directive EN55024
(2001)
Immunity to Electro-Magnetic
Disturbances
73/23/EEC
modified by
93/68/EEC
Low voltage Directive
EN 60950-1
(2001)
Product safety
1999/5/CE
R&TTE
Directive
EN300330-2 V1.1.1
Radio Frequency Interferences
Model P120i conforms to the following specification: FCC Part 15, Subpart A, Section
15.107(a) and Section 15.109(a) Class B digital device.