Installin
the Elite Modem
1-5
Revision 2.01 Elite Modem Installation Guide 08-01002-01
Task:
Installing the Modem
Note:
Some computers require an adapter between the RJ-45
Ethernet cable and the Ethernet connector on the back of the
computer (the adapter is often a round, 8-pin connector).
Step Action
1
Make sure that all of your Elite Modem equipment is available before
proceedin
.
2
Connect the RJ-45 Ethernet cable to the 10Base-T Ethernet Card connector
on the rear of your computer. Connect the other end of cable to the Ethernet
port on the rear of the modem labeled:
To PC
.
3
Your telephone is connected with an RJ-11 modular phone line cord to a
telephone wall jack. Disconnect the telephone line cord from the telephone
wall jack and insert it into the jack in the rear of the modem identified with this
icon:
4
Connect the RJ-11 modular phone cord to the connector on the rear of the
modem labeled,
To Wall Jack
. This connector is identified with a telephone
line symbol.
5
Insert the other end of the phone cord into the telephone wall jack.
6
Connect the rounded plu
end of the power supply cord into the 5V AC
connector on the rear of the modem.
7
Plu
the power supply into wall outlet. This completes the modem physical
installation. Proceed to Setup. At this point, the Power and the Loop Status
indicator li
hts should be
reen.
Note:
See “Modem Indicators” on pa
e 1-6 for more information on the Elite
modem LED indicators.
STOP
You have completed this task.