Filter
Top Products
Appendix C: Custom Installation Instructions 23
4
44
4
Make sure that the TCP/IP tab is foremost.
Highlight Manually in the Configure: menu and then enter
the static IP address 10.0.0.3 (or any IP address higher than
the Bridge’s 10.0.0.2 IP address) and the subnet mask
255.255.255.0.
5
55
5
Click Save and close the Network pane.
Changing the Linux TCP/IP Setting
The instructions for setting up boot-time DHCP vary dramatically
by distribution, so you may want to refer to your particular
version’s documentation. We have included instructions for
RedHat.
Note:
If you have other network cards installed, you will need to
pick distinct Ethernet identifiers for each (eth0, eth1, eth2,
etc.). If you select an identifier other than eth0 for your
ADSL modem, use that identifier throughout.
For RedHat
To use a static IP address, edit or create
/etc/sysconfig/network-scripts/ifcfg-eth0 so that it contains
the following lines: