Filter
Top Products
2
When the main interface appears, click Install Drivers. When
the Install Drivers screen appears, select the modem type you
are installing. Click Next. Follow the prompts. Click Finish.
Leave the CD in the drive, exit any running programs, and shut
down your computer. Continue below.
Connecting the Faxmodem
1
Make sure your computer is shut down. Locate the
faxmodem’s serial number on the bottom of its case, just
under the bar code, and make a note of it for future
reference.
Depending on your modem model, your setup should look
similar to one of the illustrations below.
Telep hone
(Optional)
Telep hone
Line
Power
Computer
2
Connect the faxmodem-to-computer serial cable. Plug one
end of the cable into the matching connector on the back of
your modem, and plug the other end of the cable into your
computer’s serial port. Some cables have an extra
connector; you should leave one unconnected. Tighten the
screws at both ends. Make a note of the COM port you plug
the modem into.
3
Connect the telephone cord. Plug one end of the cord into
the phone line jack on the back of the faxmodem. Then
plug the other end into the wall jack just as you would a
standard telephone. Note: If you do not use the supplied
telecommunications cord, use an equivalent of minimum
AWG 26 line cord.
Power
On/Off
Switch
Telephone
Line
Telephone
(Optional)
Computer