Filter
Top Products
4
6
In the Install New Modem screen, the correct modem will
be displayed. Fill in the Location Information screen if it
appears. Click Next.
7
At the Modem Properties box, select the newly installed
modem and then click Properties.
Set the Maximum speed to the highest speed available
(probably 115,200). This sets the speed at which the
computer communicates with the faxmodem. Note: Do not
check Only connect at this speed.
Click OK. Click Close.
Continue below with Installing the Communications Software.
Windows 95/98/Me/2000/XP
Turn your computer back on. Windows will detect your new
faxmodem and drivers and add the drivers to its database. If you
are using Windows 2000 or Me, you may see a dialog box
entitled Digital Signature Not Found; you can safely ignore this
screen and click Yes. If you are using Windows XP, you may see
a standard disclaimer dialog box regarding Windows logo
testing. You can safely disregard this message and click
Continue Anyway.
Note: If the Plug and Play setup does not proceed properly,
consult your full-length user’s manual.
Now you need to verify the faxmodem’s COM port setting. This
last operation also tests your faxmodem by querying it with AT
commands. The steps for Windows 95/98/Me and 2000/XP vary
slightly, as shown below.
Windows 95/98/Me:
1
Open Start | Settings | Control Panel. Double-click
Modems. Fill in the Location Information screen if it
appears. Click on the entry for your new modem and click
Properties.
2
Set the Maximum speed to the highest speed available
(probably 115,200). Note: Do not check Only connect at
this speed. Click OK.
3
Click the Diagnostics tab. Highlight the port next to the
entry for your new faxmodem and click More info.
4
Make a note of the Port and Interrupt entries under Port
Information. Click OK. Click Close. Close the Control
Panel.
Continue below with Installing the Communications Software.