Filter
Top Products
ZyWALL 10W Internet Security Gateway
2
Use a Y-cable to connect
your administration
computer or a modem
(with a cable converter)
to the CON/AUX port.
Make sure the CON/AUX
switch is pushed to the
appropriate side.
Hardware Installation
Rear Panel and Connections
The Front Panel
Refer to the User’s Guide for LED descriptions.
The PWR and CON/AUX LEDs turn on.
The SYS LED blinks and turns steady on.
The SYS LED turns red if power is too low.
The LAN, WAN and WLAN LEDs turn on, if
they are properly connected.
Reset to
default
configuration
file. See User’s
Guide.
Connect to a computer/hub
using a straight-through/
crossover Ethernet cable.
The computer must have
Ethernet NIC (Network
Interface Card) installed.
Turn off your ZyWALL.
Remove the protective
cover plate from the slot
and insert an optional
PCMCIA wireless LAN
card into the slot.
Never force, bend or twist
the wireless LAN card
into the slot.
The wireless LAN is
disabled by default.
The ZyWALL wireless
LAN may not work if you
do not use ZyAIR
wireless PC cards.
Connect to
your cable/DSL
modem.
Connect a
grounded
wire to
ground the
ZyWALL.
Do this last. Connect to a power source
using the supplied power adapter.