Filter
Top Products
ZyXEL G-120 User’s Guide
Chapter 5 Access Point Mode Configuration 65
5.4 The MAC Filter Screen
The MAC Filter screen allows you to configure the G-120 to give exclusive access to
(Accept) devices or exclude devices from (Reject) connecting to the G-120. The MAC
address is assigned at the factory and consists of six pairs of hexadecimal characters, for
example, 00:A0:C5:00:00:02. You need to know the MAC address of the device(s) to
configure this screen. See Section 3.2.2 on page 36 for more information.
Figure 41 Access Point Mode: MAC Filter
The following table describes the labels in this screen.
Table 18 Access Point Mode: MAC Filter
LABEL DESCRIPTION
Filter Type Define the filter action for the list of MAC addresses in the MAC address filter
table.
Select Disable to deactivate the MAC filter feature.
Select Reject to block access to the G-120, MAC addresses not listed will be
allowed to access the G-120.
Select Accept to permit access to the G-120, MAC addresses not listed will be
denied access to the G-120.
Filter MAC
Address 1-16
Specify the MAC address(es) of the wireless station(s) that is allowed or denied
association to the G-120.
Enter six pairs of hexadecimal digits (separated by colons) in the range of “A-F”,
“a-f” and “0-9” (for example, 00:A0:C5:00:00:02).
If you enter an invalid MAC address, once you click Save to save the values, a
warning screen will be displayed.
Save Click Save to save the changes back to the G-120.
Cancel Click Cancel to discard the changes.