Filter
Top Products
Chapter 1 Introduction
NBG-418N User’s Guide
15
1.3 LEDs
Figure 2 Front Panel
The following table describes the LEDs and the WPS button.
1.4 The WPS Button
Your NBG-418N supports WiFi Protected Setup (WPS), which is an easy way to set up a secure
wireless network. WPS is an industry standard specification, defined by the WiFi Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Each WPS connection works between two devices. Both
devices must support WPS (check each device’s documentation to make sure).
Depending on the devices you have, you can either press a button (recommended) on the device
itself, or in its configuration utility or enter a PIN (a unique Personal Identification Number that
Table 1 Front Panel LEDs and WPS Button
LED COLOR STATUS DESCRIPTION
POWER Green On The NBG-418N is receiving power and functioning properly.
Off The NBG-418N is not receiving power.
LAN 1-4 Green On The NBG-418N has a successful 10/100MB LAN connection.
Blinking The NBG-418N is sending/receiving data through the LAN.
Off The LAN is not connected.
WAN Green On The NBG-418N has a successful 10/100MB WAN connection.
Blinking The NBG-418N is sending/receiving data through the WAN.
Off The WAN connection is not ready, or has failed.
WLAN Green On The NBG-418N is ready, but is not sending/receiving data
through the wireless LAN.
Blinking The NBG-418N is sending/receiving data through the wireless
LAN.
The NBG-418N is negotiating a WPS connection with a wireless
client.
Off The wireless LAN is not ready or has failed.
WPS Green On WPS status is configured.
Blinking The NBG-418N is negotiating a WPS connection with a wireless
client.
Off The WPS status is not configured or disabled.