Filter
Top Products
Chapter 3 The ENCRYPT Button
PLA450 User’s Guide
30
Figure 4 ENCRYPT Connection Procedure
5 Repeat step 4 in this section for the other powerline device you wish to connect. This
must be done within 120 seconds of pressing the ENCRYPT button on the PLA450.
6 Check the lights on the two powerline devices. Wait for about one minute while your
powerline devices connect. The HomePlug ( ) lights on both devices turn on when the
connection is made.
V If the HomePlug ( ) lights on both powerline devices do not light up, the
powerline devices are not connected. Repeat steps 3, 4 and 5 in this
section. If that doesn’t work, see the Troubleshooting in Section 14.7 on page
120 for suggestions.
7 To add more powerline devices to your network, press the ENCRYPT button on device
C (shown below) for more than 10 seconds until the HomePlug ( ) light flashes.
8 Then repeat steps 4 and 5 in this section using any powerline device (A or B) you have
connected using ENCRYPT and the powerline device you want to connect (C). You
must use the ENCRYPT button on both devices.
press 2 seconds
press 2 seconds
within 2
minutes