Filter
Top Products
Chapter 5 Maintenance
PMG1006-B20A User’s Guide
18
The following table describes the fields in this screen.
5.3 General
Use this screen to configure the GPON Device’s system name, inactivity timer, and password. Click
Maintenance > System to open the General screen.
Figure 10 Maintenance > System > General
The following table describes the labels in this screen.
Table 5 Maintenance > SLID
LABEL DESCRIPTION
Enable SLID Select this to have the GPON Device use the SLID to identify itself to the OLT.
SLID Value Enter the SLID used for gaining access to the service provider’s network. It is case-
sensitive, so make sure [Caps Lock] is not on.
Apply Click Apply to save your changes back to the GPON Device.
Cancel Click Cancel to begin configuring this screen afresh.
Table 6 Maintenance > System > General
LABEL DESCRIPTION
General Setup
System Name Choose a descriptive name for identification purposes. Because some ISPs check this
name it is recommended you enter your computer’s “Computer name” in this field. This
name can be up to 30 alphanumeric characters long. Spaces are not allowed, but dashes
“-” and underscores "_" are accepted.
• To find your computer’s name in Windows XP, click Start > My Computer > View
system information and then click the Computer Name tab. See the Full
computer name field.
• In Windows 7, click Start, right click Computer, and click Properties. See the entry
in the Full computer name field.