Filter
Top Products
Prestige 650R-31/33 ADSL Router
4-4 Remote Node Configuration
FIELD DESCRIPTION EXAMPLE
Encapsulation
PPPoE (Point-to-Point Protocol over Ethernet).
PPPoA refers to RFC-2364 (PPP Encapsulation over ATM
Adaptation Layer 5).
If RFC-1483 (Multiprotocol Encapsulation over ATM Adaptation
Layer 5) or ENET ENCAP are selected,
then the Rem Login, Rem Password, My Login and My
Password Options and Authen fields are not applicable (N/A).
ENET ENCAP
Multiplexing Press [SPACE BAR] and then [ENTER] to select the method of
multiplexing that your ISP uses, either VC-based or LLC-based.
LLC-based
Service Name When using PPPoE encapsulation, type the name of your PPPoE
service here.
Incoming:
Rem Login
Type the login name that this remote node will use to call your
Prestige. The login name and the Rem Password will be used to
authenticate this node.
Rem Password Type the password used when this remote node calls your
Prestige.
Outgoing:
My Login
Type the login name assigned by your ISP when the Prestige
calls this remote node.
My Password Type the password assigned by your ISP when the Prestige calls
this remote node.
This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP – Your Prestige will accept either CHAP or PAP when
requested by this remote node.
CHAP – accept CHAP (Challenge Handshake Authentication
Protocol) only.
CHAP/PAP
Authen
PAP – accept PAP (Password Authentication Protocol) only.
Route
This field determines the protocol used in routing. Options are IP
and None.
IP
Bridge When bridging is enabled, your Prestige will forward any packet
that it does not route to this remote node; otherwise, the packets
are discarded. Select Yes to enable and No to disable.
No
Edit IP/Bridge
Press [SPACE BAR] to select Yes and press [ENTER] to display
Menu 11.3 – Remote Node Network Layer Options.
No