Filter
Top Products
Prestige 650R-31/33 ADSL Router
Remote Node Configuration 4-5
FIELD DESCRIPTION EXAMPLE
Edit ATM Options
Press [SPACE BAR] to select Yes and press [ENTER] to display
Menu 11.6 – Remote Node ATM Layer Options.
No
Telco Option
Allocated Budget
(min)
This sets a ceiling for outgoing call time for this remote node. The
default for this field is 0 meaning no budget control.
0
(default)
Period (hr) This field is the time period that the budget should be reset. For
example, if we are allowed to call this remote node for a maximum
of 10 minutes every hour, then the Allocated Budget is (10
minutes) and the Period (hr) is 1 (hour).
0
(default)
Schedule Sets
This field is only applicable for PPPoE encapsulation. You can
apply up to four schedule sets here. For more details please refer
to the Call Schedule Setup chapter.
Nailed up
Connection
This field is only applicable for PPPoE encapsulation. This field
specifies if you want to make the connection to this remote node a
nailed-up connection. More details are given earlier in this
section.
No
Session Options
Edit Filter Sets
Use [SPACE BAR] to choose Yes and press [ENTER] to open
menu 11.5 to edit the filter sets. See the Remote Node Filter
section for more details.
No
(default)
Idle Timeout (sec) Type the number of seconds (0-9999) that can elapse when the
Prestige is idle (there is no traffic going to the remote node),
before the Prestige automatically disconnects the remote node. 0
means that the session will not timeout.
0
(default)
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.1.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendors’ implementation includes specific authentication protocol in the user profile. It will disconnect if
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.