Filter
Top Products
Prestige 650R-31/33 ADSL Router
Remote Node Configuration 4-7
Table 4-2 Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
My WAN Addr Some implementations, especially UNIX derivatives, require
separate IP network numbers for the WAN and LAN links and each
end to have a unique address within the WAN network number. In
that case, type the IP address assigned to the WAN port of your
Prestige.
NOTE: Refers to local Prestige address, not the remote router
address.
NAT
Press [SPACE BAR] and then [ENTER] to select Full Feature if you
have multiple public WAN IP addresses for your Prestige.
None
Select SUA Only if you have just one public WAN IP address for
your Prestige. The SMT uses Address Mapping Set 255 (menu 15.1
- see section 7.3.1).
Select None to disable NAT.
Address Mapping
Set
When Full Feature is selected in the NAT field, configure address
mapping sets in menu 15.1. Select one of the NAT server sets (2-
10) in menu 15.2 (see the NAT chapter for details) and type that
number here.
When SUA Only is selected in the NAT field, the SMT uses NAT
server set 1 in menu 15.2 (see the NAT chapter for details).
2
Metric The metric represents the “cost” of transmission for routing
purposes. IP routing uses hop count as the cost measurement, with
a minimum of 1 for directly connected networks. Type a number that
approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
2
Private This determines if the Prestige will include the route to this remote
node in its RIP broadcasts. If set to Yes, this route is kept private
and not included in RIP broadcast. If No, the route to this remote
node will be propagated to other hosts through RIP broadcasts.
No
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP Direction.
Options are Both, In Only, Out Only or None.
None
Version Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are RIP-1, RIP-2B or RIP-2M.
RIP-1
Multicast
IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2
and None disables IGMP.
None