Filter
Top Products
Prestige 650R-31/33 ADSL Router
Remote Node TCP/IP Configuration 5-1
Chapter 5
Remote Node TCP/IP Configuration
This chapter shows a sample LAN-to-LAN application and how to configure TCP/IP remote node.
5.1 TCP/IP Configuration
The following sections describe how to configure the TCP/IP parameters of a remote node.
5.1.1 Editing TCP/IP Options
Follow the steps shown next to edit Menu 11.6 – Remote Node ATM Layer Options.
In menu 11.1, move the cursor to the Edit ATM Options field and then press [SPACE BAR] to select
Yes. Press [ENTER] to display Menu 11.6 – Remote Node ATM Layer Options.
There are two versions of menu 11.6 for the Prestige, depending on whether you chose VC-based/LLC-
based multiplexing and PPPoA encapsulation in menu 11.1.
VC-based Multiplexing
For VC-based multiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, for
example, VC1 will carry IP. Separate VPI and VCI numbers must be specified for each protocol.
Figure 5-1 Menu 11.6 for VC-based Multiplexing
VPI/VCI (VC-Multiplexing)
VC Options for IP: VC Options for Bridge:
VPI #= 8 VPI #= N/A
VCI #= 35 VCI #= N/A
ATM QoS Type= UBR ATM QoS Type= N/A
Peak Cell Rate (PCR)= 0 Peak Cell Rate (PCR)= N/A
Sustain Cell Rate (SCR)= 0 Sustain Cell Rate (SCR)= N/A
Maximum Burst Size (MBS)= 0 Maximum Burst Size (MBS)= N/A
Enter here to CONFIRM or ESC to CANCEL:
Separate VPI and
VCI numbers must be
specified for each
protocol.