Filter
Top Products
Chapter 25 Loop Guard
XGS-4528F User’s Guide
224
Active Select this check box to enable the loop guard feature on this port. The Switch sends
probe packets from this port to check if the Switch it is connected to is in loop state.
If the Switch that this port is connected is in loop state the Switch will shut down this
port.
Clear this check box to disable the loop guard feature.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 82 Advanced Application > Loop Guard (continued)
LABEL DESCRIPTION