A SERVICE OF

logo

39
Getting Started
Running Software that Requires SCPI Commands
[:SENSe]:RLC:BANDwidth:LIMit ON|OFF|1|0
[:SENSe]:RLC:BANDwidth:LIMit?
Toggles legacy bandwidth limiting on and off.
2
[:SENSe]:RLC:ATTenuation:STATe ON|OFF|1|0
[:SENSe]:RLC:ATTenuation:STATe?
Toggles internal attenuation on and off.
2
Defaults
to OFF.
1. After changing into or out of RLC mode, allow a 1s delay before sending subsequent com-
mands.
2. This command is only available if the N9061A application is installed on your analyzer.
Table 1-7 SCPI Commands
SCPI Commands Description