Installing the HP JetDirect Print Server Card 2-31
2
Installation
Task 4. Verify the card was installed
correctly
1. Print a new self-test page or configuration page.
2. Using the diagram on the following page as a guide, locate the
phrase “I/O CARD READY” on the self-test page.
The I/O CARD READY message is included in the MIO section
of the self-test page, which also provides information about the
following:
• Product number
• Firmware revision number
• LAN hardware address
• Port selection type
• Manufacturing identification number
• Network statistics
• Network protocol messages
NOTE
For HP 2500C/CM Professional Series and
HP DesignJet ColorPro GA printers, the MIO
information is provided on a separate HP JetDirect
self-test page, which prints immediately after the
printer’s diagnostic page.
