5. Press to exit to the Setup menu.
6. Press to exit to the Main Menu.
NOTE: After changing settings in the Setup Menu, always
return to the Main Menu before turning your
printer off. The printer will not save changes to
these menus if you turn it off before returning to
the Main Menu.
Margin Position
This function adjusts where the format prints horizontally on the
supply. The adjustments are in dots (0.0052 inch), which is the
smallest measurement the printer recognizes. The range is -99
to +99 (0.52 inches), and the default is 0.
NOTE: If you change the Margin position in the middle of
the batch, the change does not occur until the
next batch, except for variable data, such as
incrementing or decrementing fields. The
changes occur immediately in variable data fields.
Print too far to the left. Print too far to the right.
Use the following rules of thumb as you set this position:
• If the data is too close to the
left
side of the supply,
increase
the number.
• If the data is too close to the
right
side of the supply,
decrease
the number.
Setting Supply Options
3. Setting Supply Options
3-9
