Polling Reception
51
3
C
Depending which method you
are using, choose one of the fol-
lowing procedures:
Default ID Polling Reception
A Press the <
<<
< or >
>>
> key to select
the Default ID.
ID Override Polling Reception
A Press the <
<<
< or >
>>
> key to select
the Override ID.
B Enter a polling ID (4 charac-
ters) with the number keys and
the letter (A–F).
Note
❒ If you make a mistake, press
the {Clear/Stop} key and try
again.
❒ 0000 and FFFF is not available.
D
Press [OK].
The Transmission Mode menu is
shown. A check mark is added to
“Polling RX”.
Note
❒ To cancel the Polling Reception,
press [Cancel]. The Transmis-
sion Mode menu is shown.
E
Press [Exit].
The following display is shown.
Note
❒ “Polling RX” is displayed.
F
Dial and press the {
{{
{Start}
}}
} key.
Polling Reserve Report
This report is printed after Polling Re-
ception has been set up.
Note
❒ By default, this report is turned off.
Turn it on with the User Parame-
ters. ⇒ P.130 “Changing the User
Parameters”(Switch03, Bit3)
Polling Result Report
This report is printed after a Polling
Reception has been completed and
shows the result of the Polling Recep-
tion.
Note
❒ You can also check the result of a
Polling Reception with the TCR.
❒ By default, this report is turned on.
Turn it off with the User Parame-
ters. ⇒ P.130 “Changing the User
Parameters”(Switch03, Bit4)
Us98-3.tif
Us98-4.tif
Us99-1.tif
Us99-2.tif
